KE7100 LANcheck LAN Tester

Copper Wire Tests

‍
Equipped with only the KE7100 LANcheck the user is quickly able to run a single ended check that will determine cable length and identify any split pairs (beyond 6ft or 2 metres). Plug the companion KE7010 Remote Unit in to the opposite end of the link and the full range of wire tests are automatically available. Length measurement accuracy improves so over-length cables are easily identified up to 150m. The actual mapping of the conductors within the cable is clearly displayed graphically with multiple errors being able to be shown simultaneously without confusion. Now the user can seef how wires are connected to PIN and Pair. The tester measures all wires separately and shows distance to fault short/open in order to speed troubleshooting. To speed preparation the product has 16 dedicated wiring schemes predefined, and 16 cable types with predefined VP values available to select. User on the device

PoE Testing

‍

Testing with the product quickly exercises activation of PoE/PoE+/PoE++ port and measures actual voltage and current limits under varying load conditions to determine and show the actual available power in watts. This is all carried out in compliance with the IEEE802.3af/at standards.

‍

Cable Tracing

‍

Selecting the Hub-Link Blink function will cause the tester to attempt to activate the network port it is connected to. This will obviously only work if it is connected to an active network device and when successful a connection confirmation message is displayed indicating the connected speed for the port. A blinking port lamp will show clearly the port on the active device being tested. When there is no connection possible and hence no active equipment connected test tones can then be sent down all wire pairs in one of four fixed or warble tones to be scanned for and detected by capacitive Probe (optional)